Factory Reset a Juniper SSG5 Firewall

I was restoring a Juniper SSG5 firewall to its default settings. There are two ways in doing this: a quick way is using the reset pinhole at the back and the other is by typing its serial number via command line. I prefer doing the latter and here's how I did it

login: 0162052012003235   // USE THE SERIAL NUMBER FOR BOTH LOGIN/PASSWORD
password:
!!! Lost Password Reset !!! You have initiated a command to reset the device to factory defaults, clearing all

current configuration and settings. Would you like to continue?  y/[n] y

!! Reconfirm Lost Password Reset !! If you continue, the entire configuration of the device will be erased. In

addition, a permanent counter will be incremented to signify that this device has been reset. This is your last

chance to cancel this command. If you proceed, the device will return to factory default configuration, which is:

System IP: 192.168.1.1; username: netscreen, password: netscreen. Would you like to continue?  y/[n] y
In reset ...


Juniper Networks SSG5 Boot Loader Version 1.3.3 (Checksum: D8BC25A8)
Copyright (c) 1997-2006 Juniper Networks, Inc.

Total physical memory: 256MB
    Test - Pass
    Initialization - Done

Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader

Loading default system image from on-board flash disk...
Done! (size = 13,369,344 bytes)

Image authenticated!

Start loading...
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
..............................................................
Done.



Juniper Networks, Inc
SSG5/SSG20 System Software
Copyright, 1997-2008

Version 6.3.0r12.0
Cksum:26cde5cd
Load Manufacture Information ... Done

Initialize FBTL 0........ Done
Load NVRAM Information ... (6.3.0)Done
Install module init vectors
Changed to l3 mode
Install modules (01270800,020b4000) ...
PPP IP-POOL initiated, 256 pools

Initializing DI 1.1.0-ns

*********************************************************
System time: 24Sept2013:21:51:00
If this is the initial device startup,
use the "set clock" command to set the system clock.
*********************************************************
system init done..
System change state to Active(1)

login: netscreen
password:
ssg5-serial-> get system
Product Name: SSG5-Serial
Serial Number: 0162052012003235, Control Number: 00000000
Hardware Version: 0710(0)-(00), FPGA checksum: 00000000, VLAN1 IP (0.0.0.0)
Flash Type: Samsung
Software Version: 6.3.0r12.0, Type: Firewall+VPN
Feature: AV-K
BOOT Loader Version: 1.3.3
Compiled by build_master at: Wed Aug 8 05:12:11 PDT 2012
Base Mac: a8d0.e5d2.2c80
File Name: ssg5ssg20.6.3.0r12.0, Checksum: 26cde5cd
, Total Memory: 256MB

Date 09/24/2013 21:59:41, Daylight Saving Time enabled
The Network Time Protocol is Disabled
Up 0 hours 8 minutes 41 seconds Since 24Sept2013:21:51:00
Total Device Resets: 1, Last Device Reset at: 09/24/2013 20:48:01

<OUTPUT TRUNCATED>

ssg5-serial-> save
Save System Configuration  ...
Done